Blender
Scenario Name:
SBR (Thickener) Flow Management
Requirement:
To manage the flow rate of thickener added to achieve a specific viscosity for slurry.
Too much or too little can affect quality, so quantitative management is essential. A clamp-on flow sensor can be installed outside the piping and can also measure high-viscosity liquids.
Solution:
Clamp-on flow sensor
Scenario Name:
Monitor door opening and closing
Requirements:
If the door is opened during operation, power to the hazardous source will be cut off. Furthermore, the door can be locked to prevent unnecessary equipment downtime and reduced production efficiency.
The inching and guide mechanism can address door misalignment and loosening.
Solution:
SDS04 Series Safety Door Switch
Scenario Name:
Slurry Level Detection
Requirements:
Liquids with high viscosity often require frequent maintenance when using float-type or electrode-type sensors due to liquid adhesion. The FL series, with its lack of moving parts, requires no maintenance and offers long-term, stable operation.
Solution:
Photoelectric liquid level sensor
Scenario Name:
Pressure detection of high-viscosity liquids
Requirements:
The flush structure of the parts contacting the liquid requires no maintenance due to dirt or clogging, and can be used for a long time. The large indicator light provides high visibility, and the digital display function contributes to the visualization.
Solution:
Corrosion-resistant pressure sensor
Coating machine
Scenario Name:
Coating Liquid Flow Management
Requirement:
Measure and control the flow rate of coating liquid. Since the flow sensor is mounted outside the piping, stable measurement is possible even with high viscosity liquids. Supporting both analog and digital outputs, data can also be acquired.
Solution:
Clamp-on flow sensor
Scenario Name:
Preventing people from staying inside the safety barrier
Requirement:
The requirement was to not only use the door switch to check the open/close status of the safety barrier door, but also to use a laser scanner to detect when someone was inside, thus preventing the equipment from accidentally restarting.
Solution:
RLD Series LiDAR
Scenario Name:
Detecting Thin and Thick Rolls
Requirements:
Detect the distance to the roll material in a non-contact manner and monitor the remaining amount.
Solution:
EST-3D Series TOF Laser Ranging
Scenario Name:
Managing bearing lubricant flow
Requirements:
Easy installation outside the piping, accurate measurement even of low flow rates. Repairing a damaged bearing is time-consuming and expensive. Maintaining the proper flow rate of lubricating oil can prevent damage to the machine.
Solution:
Clamp-on flow sensor
